question on drawing from vials

[moneyshot11]

ok i am on my second cycle here but have noticed a re-occuring problem when i go to draw my liquid (test E and EQ) into my pin. I am drawing with a 20g and pinning with a 23g. anyways onto the problem-i pull back to 1ml of air-put the pin into the vial push the air back into the vial then draw up my 1ml of juice. the problem is when i go to draw the juice it becomes very hard to get it into the vial-sometimes i pull back all the way to the 3-4ml mark and just barely get my desired 1ml of liquid. (sort of just drips into the vial-very slowly) this happened on my last cycle towards the end though. But i am in my 3rd week and its already starting to become a problem. Am i doing something wrong or is this supposed to happen.

[t_dot_porkchop]

turn the vial up-side-down so when you inject air into it, it is in the liquid.

[moneyshot11]

yea i have been doing it upside down-and usually i try and keep the pin tip in the liquid-do you think that maybe there is too much air creating a vacuum seal too tight?

[workoutbug]

Try not pulling back so far before you start. It sounds like you have a little too much vacuum and the more you air you push in the greater the vacuum.

Also, you are not reusing your needles are you?

[Poobah]

put more then 1ml of air into the vial... pump in 2ml of air and then draw out 1ml of gear... then in the future, push in 1-1.5ml and draw out 1ml.

Also warm your gear up if you have it in a cool place, it will run thicker and be harder to draw when cold.

[Caferacer]

Originally Posted by Poobah

put more then 1ml of air into the vial... pump in 2ml of air and then draw out 1ml of gear... then in the future, push in 1-1.5ml and draw out 1ml.

Also warm your gear up if you have it in a cool place, it will run thicker and be harder to draw when cold.

This worked when I injected B12. If there is pressure in the vial, it will help to push whatever it is into the syringe and out of the vial.