Test Prop Q!

[Fritzer]

i recently got some British Dragon test prop.

100mg/ml, it is the legit stuff

it has a solid substance in it...looks kinda crystally, and sinks to bottom slowly....

is this normal ever? do i have to heat it up?

THX!

[Caferacer]

If it is crystals, it's probably gear that has fallen out of solution.

Sometimes it's not that uncommon having gear sent through very cold climates to have some of it fall out. Try heating it in a pot of warm water and shaking it, that should make it go back into solution. Then just wai a few days to see if it crashes again (It shouldn't since it is BD) and you are good to go.

[Fritzer]

it is cold here for sure...is it still ok then??

also, they look like crystals...is this normal?? its like half the size of a penny..

thanks

[Caferacer]

Originally Posted by Fritzer

it is cold here for sure...is it still ok then??

also, they look like crystals...is this normal?? its like half the size of a penny..

thanks

get it back into solution, and don't inject it until then. It's still ok you just need to get it back into solution.

Yes, it is normal. Most gear will be crystallian when it falls out of solution.

[Fritzer]

do i put it in a ziploc then in a pot of BOILING water??

[Caferacer]

Originally Posted by Fritzer

do i put it in a ziploc then in a pot of BOILING water??

It doesn't need to be boiling, just enough to warm the vial up some. Like non scalding temps.

I don't see any reason why putting it in a ziploc wouldn't work. Just make sure to get most the air out of it.

[devildriver]

If you get it too hot it will explode man! Pop a 25g pin or whatever you got in the top to vent the pressure. Just put a bit of water in a pan and get it nice and hot, but that glass is usually pretty thin, so be careful!